How to start using of CALL2UA telephone service?
You have to register and replenish your balance.
How to start calling with the computer with NetMeeting?
Detailed description of Microsoft NetMeeting adjustment is on home
page of this site in the section "Microsoft NetMeeting adjustment".
How to start calling with the computer through the block CISCO ATA 186?
Detailed description of CISCO ATA 186 adjustment is on home page
of this site in the section "CISCO ATA 186 adjustment".
At attempt to call through Microsoft NetMeeting the mistake of
connection to server is displayed?
Most likely you incorrectly entered your ID address or IP-address
of your server. Pay attention on the version Microsoft NetMeeting.
Version 3.0 has many mistakes and doesn't allow to make calls in
normal mode. We strongly recommend to update it minimally to the
version 3.1. The latest version you can load from
What minimal speed of connection with Internet is needed for conversation?
We recommend to use codec G.723.1. At that connection
speed 28800 (28k) is completely enough for normal call.
Connection proceeds at call, but I hear nothing ?
Check:
1) if sound card drivers are installed
2) if headers are connected to proper connector
3) volume regulator directly in headers (if exists)
4) volume regulator on computer in the panel of volume regulators
5) is it possible to reproduce any standard WAV files by any sound record-player
6) try to change DirectSound parameter in NetMeeting installation settings
I hear at call, but I am not heard?
Check:
1) selected audio-codec, it should be G.723.1
2) that microphone is connected to proper connector
3) 3) in the panel of volume regulators, that microphone channel
is selected and that its recording level is on maximum
I try to turn on microphone channel in the panel of regulators but I hear strong peep?
This peep appears because you switch turn on channel on reproducing.
This is mistake. Microphone must be turned off on reproducing channel
and turned on recording channel only. For changing to recording
channels select in the panel of volume regulators in menu:
Parameters -> Properties -> Record -> OK.
Besides, peep can arise because some sound loop back from loud
speakers to the microphone. We recommend to use headers rather but
not desk loud speakers.
When I call and simultaneously browse Internet there are signal interruptions ?
This situation can arise because of shortage of connection speed
with Internet for simultaneous audio transmission and browsing
of Internet pages. This is typical situation at dial-up connection
with low speed. We recommend to close InternetExplorer and mail
programs for a time of telephone conversation.
When I call and simultaneously print a document signal interruption arise ?
This situation can arise because power of your processor in computer is
not sufficient for simultaneous sound processing and work of other tasks.
We recommend to close all unnecessary programs at a point of conversation.
Computer of what minimal power is needed for call proceeding?
If you don't start other programs at a time of call through NetMeeting,
Pentium 166-MMX with RAM = 32 MB is quite enough.
What operational system is needed ?
For work of Microsoft NetMeeting practically every Windows
version matches. We recommend to use Windows-98.
You have not found an answer to a question ?
Don't hesitate to question us. You can question us by e-mail,
indicated in the section "Contact information".
Cheap International Phone Calls ! Cheap Low Price International Phone Calls ! Cheap International Phone Calls ! Cheap Low Price International Phone Calls !
Return to main page
Cheap International Phone Calls ! Cheap Low Price International Phone Calls ! Cheap International Phone Calls ! Cheap Low Price International Phone Calls !
Detailed description of Microsoft NetMeeting adjustment is on home page of this site in the section "Microsoft NetMeeting adjustment".
How to start calling with the computer through the block CISCO ATA 186?
At attempt to call through Microsoft NetMeeting the mistake of
connection to server is displayed?
What minimal speed of connection with Internet is needed for conversation?
Connection proceeds at call, but I hear nothing ?
I hear at call, but I am not heard?
I try to turn on microphone channel in the panel of regulators but I hear strong peep?
When I call and simultaneously browse Internet there are signal interruptions ?
When I call and simultaneously print a document signal interruption arise ?
Computer of what minimal power is needed for call proceeding?
What operational system is needed ?
You have not found an answer to a question ?
Don't hesitate to question us. You can question us by e-mail,
indicated in the section "Contact information".
Detailed description of CISCO ATA 186 adjustment is on home page
of this site in the section "CISCO ATA 186 adjustment".
Most likely you incorrectly entered your ID address or IP-address
of your server. Pay attention on the version Microsoft NetMeeting.
Version 3.0 has many mistakes and doesn't allow to make calls in
normal mode. We strongly recommend to update it minimally to the
version 3.1. The latest version you can load from
We recommend to use codec G.723.1. At that connection
speed 28800 (28k) is completely enough for normal call.
Check:
1) if sound card drivers are installed
2) if headers are connected to proper connector
3) volume regulator directly in headers (if exists)
4) volume regulator on computer in the panel of volume regulators
5) is it possible to reproduce any standard WAV files by any sound record-player
6) try to change DirectSound parameter in NetMeeting installation settings
Check:
1) selected audio-codec, it should be G.723.1
2) that microphone is connected to proper connector
3) 3) in the panel of volume regulators, that microphone channel
is selected and that its recording level is on maximum
This peep appears because you switch turn on channel on reproducing.
This is mistake. Microphone must be turned off on reproducing channel
and turned on recording channel only. For changing to recording
channels select in the panel of volume regulators in menu:
Parameters -> Properties -> Record -> OK.
Besides, peep can arise because some sound loop back from loud
speakers to the microphone. We recommend to use headers rather but
not desk loud speakers.
This situation can arise because of shortage of connection speed
with Internet for simultaneous audio transmission and browsing
of Internet pages. This is typical situation at dial-up connection
with low speed. We recommend to close InternetExplorer and mail
programs for a time of telephone conversation.
This situation can arise because power of your processor in computer is
not sufficient for simultaneous sound processing and work of other tasks.
We recommend to close all unnecessary programs at a point of conversation.
If you don't start other programs at a time of call through NetMeeting,
Pentium 166-MMX with RAM = 32 MB is quite enough.
For work of Microsoft NetMeeting practically every Windows
version matches. We recommend to use Windows-98.
Cheap International Phone Calls ! Cheap Low Price International Phone Calls ! Cheap International Phone Calls ! Cheap Low Price International Phone Calls !
Return to main page
Cheap International Phone Calls ! Cheap Low Price International Phone Calls ! Cheap International Phone Calls ! Cheap Low Price International Phone Calls !