CISCO ATA-186
Instruction on adjustment of Cisco ATA 186.

Connect Cisco ATA 186 to Internet, to power supply and to telephone devices. It is sufficient to have one telephone device, connected to the line No. 1. Telephone device should work in tone dialing mode.

If DHCP is used in your network, Cisco ATA 186 receive an address automatically.
To learn what exactly address Cisco ATA 186 is received, it is necessary:

1. Rise the hand set on telephone device, connected to the line 1.

2. Press big button, located on upper panel of Cisco ATA 186.

3. In telephone hand set you will hear an invitation to enter commands.

4. Enter [ 2 ][ 1 ][ # ], after that Cisco ATA 186 will say its IP-address in English.

5. Put the hand set on telephone.

If DHCP is not used in your network, you need to set IP-address and other parameters using telephone set.

1. Rise the hand set on telephone, connected to line 1.

2. Press big button, located on the upper panel of Cisco ATA 186.

3. In telephone hand set you will hear an invitation to enter commands.

4. Dial [ 2 ][ 0 ][ # ][ 0 ][ # ] for disconnection of DHCP, after that Cisco ATA 186 will say in voice entered value and propose to press:
[ 1 ] for changing
[ 2 ] for repeating
[ 3 ] for saving
[ 4 ] for return to previous value
[ # ] for exit to main configuration menu

5. Enter [ 1 ][ # ][ 1 ][ 1 ][ 1 ][ * ][ 2 ][ 2 ][ 2 ][ * ][ 3 ][ 3 ][ * ][ 4 ][ 4 ][ # ] for entering IP-address 111.222.33.44,
than [ 3 ] for saving the parameter. We draw your attention, that instead of 111.222.33.44 you need to enter your IP-address, which was allotted to you by Internet-provider or by network administrator.

6. Enter [ 1 ][ 0 ][ # ][ 2 ][ 5 ][ 5 ][ * ][ 2 ][ 5 ][ 5 ][ * ][ 2 ][ 5 ][ 5 ][ * ][ 0 ][ # ]
for entering subnet mask 255.255.255.0 and than dial [ 3 ] for saving the parameters.

7. Enter [ 2 ][ # ][ 8 ][ 2 ][ * ][ 1 ][ 4 ][ 6 ][ * ][ 5 ][ 1 ][ * ][ 3 ][ 2 ][ # ]
for entering router address 82.146.51.32 and than dial [ 3 ] for saving the parameter.

ATTENTION!!!
Software version, supplied with Cisco ATA 186 (usually IOS 2.13 or lower) - doesn't allow to operate the device normally. It is necessary to update the software in Cisco ATA 186 up to version IOS 2.14 or IOS 2.15.

Return to main page